TM 5-3805-262-34
3-5. STARTER REPAIR (CONT)
REASSEMBLY (SHEET 3 OF 6)
s. Assemble plate and frame assembly:
(1)
(2)
(3)
(4)
(5)
(6)
Using vise or hydraulic
press and sleeve, press new
bushing (22) into frame as-
sembly (21) until flush with
top of bore.
Install oil wick (26) in frame
assembly (21). Saturate wick
with clean engine oil.
Install new plug (25) and
O-ring (24). Dent plug (25)
using ball-peen hammer to
secure.
Install three screws (19) to secure plate assembly (20)
(21).
If removed, install four new springs (18)
LEGEND
in plate assembly (20).
Install four brushes (17) and screws (16)
on plate assembly (20). Push brushes into
to frame assembly
1. Nuts (2)
2. Lock washers (2)
3. Electrical lead
4. Washer
5. Bushing
6. Nut
7. Washer
8. Connector
9. Capscrews (4)
10. Solenoid
11. Plugs (2)
12. Gaskets (2)
13. Screws (2)
14. Capscrews (4)
15. Lock washers (4)
16. Screws (4)
17. Brushes (4)
18. Springs (4)
19. Screws (3)
20. Plate assembly
raised position and hold using springs
21. Frame assembly
(18).
22. Bushing
23. Thrust washer
t. Slide thrust washer (23) onto armature (27)
24. O-ring
shaft.
25. Plug
26. Oil wick
27. Armature
3-244
