TM 5-3805-262-34
REMOVAL (SHEET 2 OF 5)
(2)
(3)
(4)
At right side of transmission, at control valve, disconnect two front
wiring harness spade terminals from clutch pressure switch spade
terminals. Do this by grasping terminals with fingers and firmly pulling
apart.
At front wiring harness orange-green wire,
separate fuseholder halves by
grasping with fingers, pushing together,
twisting counterclockwise, and
pulling apart.
Pull 40 ohm resistor from fuseholder half. Assemble fuseholder halves by
grasping both in your fingers,
alining, then firmly pushing them together
and twisting clockwise.
3-251
