TM 5-3805-262-343-6. WIRING HARNESSES MAINTENANCE (CONT)b. RearWiringHarness.This task covers removal and installation of rear wiringharness.TOOLS: No. 1 Common Organizational Maintenance Tool KitKnifeTorque wrench, 1/2 inch driveCombination box and open end wrench setScrewdriverAutomotive Mechanic’s Tool KitSocket wrench set, 1/2 inch driveMATERIALS/PARTS: Electrical cleaner (Appendix C, item 44)Electrical sealer (Appendix C, item 45)Tie straps (AR) (FSCM 53421 PN T50R0W)Rear wiring harness (FSCM 10988 PN L112378)PERSONNEL REQUIRED: TWO Construction Equipment Mechanics MOS 62BREFERENCES: TM 5-3805-262-10TM 5-3805-262-20NOTEPRELIMINARY PROCEDURE: Engine side panels removed (refer to TM5-3805-262-10) and battery ground cable disconnected (refer to TM5-3805-262-20).REMOVAL (SHEET 1 OF 6)NOTEIf necessary, refer to TM 5-3805-262-20for steps (1) through (30) below and forwiring diagram.When removing nuts, screws, and washers todisconnect rear wiring harness terminals,reinstall nuts, screws, and washers oncomponent from which terminal wasdisconnected to prevent loss of theseparts. When removing clamps to free rearwiring harness for removal, reinstallclamp and associated hardware in samelocation as removed to aid installation ofharness.(1) Disconnect front wiring harness connec-tor from rear wiring harness connector.Do this by pushing connector nut, turn-ing it counterclockwise, and pullingfirmly.3-267
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
