TM 5-3805-262-34
3-6. WIRING HARNESSES MAINTENANCE (CONT)
c. Blackout Lights Wiring Harness (Cont).
REMOVAL (SHEET 2 OF 3)
(lo)
(11)
(12)
(13)
(14)
(15)
(16)
At left front of engine block,
remove hardware securing clamp
holding rear wiring harness and
blackout lights wiring harness.
Remove blackout lights wiring
harness from clamp.
cut, remove, and discard tie
straps securing blackout lights
wiring harness to rear wiring
harness.
At transmission, remove cap-
screw securing clamp holding
rear wiring harness and black-
out lights wiring harness. Re-
move blackout lights wiring
harness from clamp.
Below cab, near transmission to
front of front wiring harness
connector, remove nut (1), lock
washer (2)$ and clamp (3). Re-
move clamp from blackout lights
wiring harness and reinstall
clamp.
Repeat step (13) above to
remove other clamp shown.
At blackout driving light, disconnect
blackout lights wiring harness green wire
terminal from blackout driving light termi-
nal. Do this by grasping with fingers and
firmly pulling apart.
At left front fender, pull blackout lights
wiring harness green wire through three
clamps. If necessary, remove hardware se-
curing three clamps. Remove clamps one at a
time, remove blackout lights harness green
wire from clamps, then reinstall clamps
loosely.
LEGEND
1. Nuts (2)
2. Lock washers (2)
3. clamps (2)
4. Capscrews (2)
5. clamps (2)
6. Spacers (2)
7. Nuts (2)
8. Lock washers (2)
9. clamps (2)
10. Spacers (2)
11. clamps (2)
12. Capscrews (2)
3-290
