TM 5-3605-262-34
3-6. WIRING HARNESSES MAINTENANCE (CONT)
C. Blackout Lights Wiring Harness (Cont).
INSTALLATION (SHEET 1 OF 5)
(1)
( 2 )
( 3)
( 4)
( 5)
Put new blackout lights wiring harness in cab. Route end opposite block-
type connector through grommet in floor plate to assistant.
Route blackout lights wiring harness block-type connector alongside front
wiring harness to front wiring harness block-type connector beneath right
instrument panel. Connect these connectors. Do this by alining connector
slots with tabs and pushing firmly.
Use three tie straps spaced evenly to tie blackout lights wiring harness
to front wiring harness.
Tell assistant to slowly pull blackout lights wiring harness through
grommet in floor plate. Position harness so that harness follows contour
of front wiring harness. Put floor mat back into position.
Beneath cab deck, route blackout lights wiring harness green wire branch
to blackout driving light mounted on left front fender. Route alongside
front wiring harness branch going to driving and flood lights. Use three
tie straps spaced evenly to secure harnesses to tilt and lift cylinder
tubes.
3-292
