TM 5-3805-262-34
CLEANING
(1)
Clean gasket (5) using clean cloth moistened with brake fluid.
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
Wear protective goggles and gloves and use only in a well ventilated
area. Avoid contact with skin, eyes and clothes and don’t breathe
vapors. Do not use near open flame or excessive heat and don-t smoke
when using it. Failure to do so could cause serious injury. If YOU be-
come dizzy while using cleaning solvent, get fresh air and medical
attention immediately.
If contact with skin or clothes is made, flush
with large amounts of water. If contact with eyes is made, wash eyes
with water and get medical aid immediately.
(2)
Clean cap and dipstick (4) and interior of body (9) using cleaning sol-
vent P-D-680. Dry using clean cloths. Rinse using clean brake fluid until
all traces of cleaning solvent P-D-680 are removed.
(3) Clean remaining parts using cleaning solvent P-D-680. Dry using clean
cloths.
INSPECTION
NOTE
Replace an item if inspection indicates need for replacement.
(1)
Inspect cap and dipstick (4) and reservoir body (9) for cracks, dents,
distortion, or other damage.
(2) Inspect gasket (5) for cracks, deterioration, wear, or damage.
(3) Inspect remaining parts for cracks, distortion, or thread damage.
REASSEMBLY
(1)
Install nut (8), washer (7), and fitting (6) in body (9).
(2)
Install gasket (5) and cap and dipstick (4).
(3) Install capscrew (3), lock washer (2), and nut (1).
3-425
