TM 5-3805-262-34CLEANING AND INSPECTIONDry cleaning solvent P-D-680 used to cleanWear protective goggles and gloves andparts is toxic and flammable.use only in a well ventilatedarea. Avoid contact with skin, eyes and clothes and don’t breathevapors. Do not use near open flame or excessive heat and don’t smokewhen using it. Failure to do so could cause serious injury. If you be-come dizzy while using cleaning solvent, get fresh air and medicalattention immediately.If contact with skin or clothes is made, flushwith large amounts of water.If contact with eyes is made, wash eyeswith water and get medical aid immediately.(1)(2)(3)(4)(5)Clean all parts using cleaning solvent P-D-680. Dry using clean cloths.Measure inside diameter of bearings infront cover (15) and rear cover (3) usingbore gage and micrometer. Replace frontcover or rear cover if bearing inside di-ameter exceeds 0.5015 inch.Measure drive gear (7) and driven gear (8)width using micrometer. Replace drive gearor driven gear if width is less than 1.0562inch.Measure drive gear (7) and driven gear (8) shaft diameter using microme-ter. Replace if shaft diameter is less than 0.4998 inch.Check gear bores in center body (5) for scoring, gouges, or other damage.Replace if any of these conditions is seen.3-537
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
