TM 5-3805-262-343-19. BODY AND CAB MAINTENANCE (CONT)c. DoorAssemblies(Cont).REASSEMBLY (SHEET 2 OF 2)(n) Install foam strip (33).(o) Position four clip nuts (24);three on lower door (12) and one on latchcover (31) at hole located on closed end of cover.(p) Position panel door cover (23) and install nut (25), washer (22), lockwasher (21), and capscrew (20). Don’t tighten capscrew (20).(q) Position latch cover (31) and install washer (30), lock washer (29), andscrew (28); don’t tighten screw (28).(r) Install, but don’t tighten, four washers (22), lock washers (21), andcapscrews (20).(s) Tighten five capscrews (20) and screw (28).(t) Install handle (27) and secure using setscrew (26).(u) Install seals (18 and 19) on lower door (12).(4)Assemble upper door assembly (14 thru 17) as follows:(a) Position upper door latch (17) on upper door (4) inside plate.(b) Install and tighten two capscrews (14), lock washers (16), and nuts(15).INSTALLATION (SHEET 1 OF 2)(1)(2)(3)(4)(5)(6)(7)(8)3-598Install new seal (13), if removed.Position hinge bracket (11) and hinge assembly (10) at lower most cabbracket.Install and tighten carriage bolt (6), washer (9), lock washer (8), andnut (7).Position hinge assembly (10) at next highest cab bracket. Install andtighten carriage bolt (6), washer (9), lock washer (8), and nut (7).Position two hinge brackets (5) and lower door (12).Position two washers (3) and drive two hinge pins (2) through cab brack-ets, hinge brackets (5), and hinge assemblies (10).Install and spread two new cotter pins (1).Position hinge bracket (11) and hinge assembly (10) at uppermost cabbracket.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business