TM 5-3805-262-34
3-23. CONTROL LEVERS AND LINKAGES MAINTENANCE (CONT)
DISASSEMBLY
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m.
If necessary, loosen and remove three knobs (20).
Loosen three nuts (24). Unscrew and remove clam control lever (21), bucket
control lever (22), and lift arm control lever (23) and three lock washers
(25) .
If necessary, remove three nuts (24) from control levers (21 thru 23).
Remove three cotter pins (26) and clevis pins (27).
Loosen three nuts (29). Position bellcranks (43) so that you can loosen and
remove three clevis (28) and nuts (29).
Remove three cotter pins (30) and clevis pins (31).
Carefully withdraw three control link rods (32) from bottom of control sup-
port (46) and through seals (37).
Remove four nuts (33), lock washers (34), washers (35), and capscrews (36).
Remove seal retainer (38) with three seals (37) installed from control sup-
port (46). Carefully remove three seals from seal retainer.
Remove seal (39).
If necessary, remove six lubrication fittings (40 and 41) from bellcranks
(43 and 45).
Using hammer and drive pin punch, drive knurled end of shaft (42) from con-
trol support (46). Remove three bellcranks (43) from shaft then remove
shaft from control support.
Using hammer and drive pin punch, drive knurled end of shaft (44) from con-
trol support (46). Remove three bellcranks (45) from shaft then remove
shaft from control support.
3-710