TM 5-3805-262-34(1) Install plug (4) in cylinder block (8).(2) Install plug (3).(3) Install five plugs (2).(4) If necessary to install five new plugs (5 thru 7), apply non-hardeningsealant to outer edge of each plug. Position each plug in cylinder blockbore and tap into position using hammer.Temperature of solid carbon dioxide (dry ice) is below -70 degrees F.Wear insulated gloves in following step to prevent severe skin injury.If skin is injured by contact with dry ice, flush with large amounts ofcold water to raise temperature above freezing point and obtain medicalaid immediately.(5) If removed, install oil filler tube (1) by chilling tube with dry ice andinstalling smooth end in cylinder block (8).(6) Install cylinder sleeves (page 4-10) .LEGEND1. Oil filler tube2. Plugs (5)3. Plug4. Plug5. Plug6. Plug7. Plugs (3)8. Cylinder block4-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
