TM 5-3805-262-34
4-1. ENGINE MAINTENANCE (CONT)
b. Cylinder Sleeves (Cont).
INSTALLATIION (SHEET 1 OF 2)
NOTE
Before you install cylinder sleeve (1), be sure cylinder sleeve (1)
flanges and cylinder block bores are free of dirt. Improper seating of
cylinder sleeve (1) due to presence of dirt may result in coolant leaks
or distortion.
NOTE
Do not install O-rings (2) on
cylinder sleeve (1) when
performing steps (1) through
(3) below.
(1) Using only the palms of your
hands, push cylinder sleeve (1)
into cylinder block.
(2)
Install clamping disk, ball,
and clamp bar. Tighten cap-
screws to 50 lb-ft.
LEGEND
1. Cylinder sleeve
2. O-rings (3)
4-10
