TM 5-3805-262-34INSPECTION(2)(3)(SHEET 2 OF 2)Using bore gage and micrometer,measure inside diameter of eachcylinder sleeve (1) just belowtop ring location and at sever-al points down length of sleeveto check taper. Replace sleeveif taper exceeds 0.002 inch.Using bore gage and micrometer,check each cylinder sleeve (1)for out-of-roundness. Make twomeasurements 90 degrees apartjust below top ring location.Replace sleeve if out-of-roundness exceeds 0.002 inch.4-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
