CLEANING - TM-5-3805-262-34

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
938

TM 5-3805-262-34 CLEANING Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes and clothes and don’t breathe vapors. Do not use near open flame or excessive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you be- come dizzy while using cleaning solvent, get fresh air and medical attention immediately. “If contact with skin or clothes is made. flush with with (1) (2) large amounts of water. If contact with eyes is made, was-h eyes water and get medical aid immediately. Clean cylinder head (4) using cleaning solvent P-D-680. Dry using clean cloths. Remove all carbon and gasket material from cylinder head (4) machined surfaces using clean cloth moistened with cleaning solvent P-D-680. INSPECTION/REPAIR (SHEET 1 OF 2) NOTE Replace an item if inspection indicates need for replacement. (1) Inspect cylinder head (4) for cracks, fretting, or erosion. (2) Check cylinder head (4) for warpage as follows: (a) Lay straight edge diagonally from corner to corner of cyl- inder head (4) bottom surface. (b) Try to insert 0.005 inch thickness gage under straight edge. (c) Reposition straight edge across the other two corners of cylinder head (4) bottom surface and repeat step (b) above. If 0.005 inch thickness gage fits under straight edge, resurface or replace cylinder head (4). After resurfacing, replace cylinder head if height is less than 4.080 inches. (3) Check plugs (1 and 2) for looseness and damage. 4-13

Privacy Statement
Press Release
Contact