TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0096 03
427-B1853
1. Check control and harness.
1. If voltage is between 4.5 and 8.0 DCV,
(a) Disconnect wiring harness connector
replace fuel sending unit (WP 0177
from fuel level sending unit (TM 5-
00).
3805-290-10).
2. If voltage is not between 4.5 and 8.0
(b) Turn battery disconnect switch and
DCV, go to Test 2.
engine start switch to ON position (TM
(c) At sender wiring harness connector,
measure voltage (DCV) between signal
contact 1 (wire 447 PK) and return
contact 2 (wire 202 BK).
2. Check harness return circuit.
1. If resistance is less than 5.0 Ohms, go
(a) Sender remains disconnected.
to Test 3.
(b) Turn battery disconnect switch and
2. If resistance is greater than 5.0 Ohms,
engine start switch to OFF position
there is an open circuit between ground
contact and frame ground. Replace
(c) Disconnect J1 and J2 wiring harness
wiring harness in question (WP 0169
connectors from ECM (TM 5-3805-
00 thru WP 0175 00).
290-10).
(d) Measure return circuit resistance
between sender wiring harness contact
2 (wire 202 BK) and ECM wiring
harness contact J1-23.
