TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1. If voltage is 8 DCV, go to Test 2.
1. Check for power at sensor.
0177 03 -
(a) Do not disconnect harness connector
2. If voltage is not 8 DCV, +battery circuit
Cont.
from sensor.
in wiring harness has failed. Replace
(b) Turn engine start switch and battery
wiring harness in question (WP 0169
disconnect switch to ON position (TM
00 thru WP 0175 00).
(c) At back of harness connector for all
sensors, insert multimeter probe along
voltage supply wire (contact A).
(d) Measure voltage from contact A to
frame ground.
1. If resistance is less than 5.0 Ohms, go
2. Check for proper ground at sensor.
to Test 3.
(a) Wiring harness remains connected to
2. If resistance is greater than 5.0 Ohms,
sensor.
ground circuit in wiring harness has
(b) Turn engine start switch and battery
failed. Replace wiring harness in
disconnect switch to OFF position (TM
question (WP 0169 00 thru WP 0175
00).
(c) Remove multimeter probe from
voltage supply wire (contact A).
(d) At back of sensor harness connector,
insert multimeter probe along ground
wire (contact B).
(e) Measure resistance from contact B to
frame ground.
3. Check sensor wiring harness for an open
1. If resistance measurement is less than
circuit.
5.0 Ohms, go to Test 4.
(a) Engine start switch and battery
2. If resistance is greater than 5.0 Ohms,
disconnect switch remain in OFF
there is an open circuit in wiring
position (TM 5-3805-290-10).
harness. Replace wiring harness in
(b) Disconnect wiring harness from
question (WP 0169 00 thru WP 0175
sensor.
00).
(c) At sensor harness connector, connect a
jumper wire between contact B and
contact C.
(d) Disconnect wiring harness
connector(s) from ECM (WP 0052 00).
(e) At ECM harness connector, measure
resistance between contact C and
contact J2-24 (wire 428 OR).
0009 00-14