TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
3. Check for a shorted harness.
1. If each resistance measurement is
0096 03 -
(a) Sender and ECM remain disconnected
greater than 5,000 Ohms, replace
Cont.
from wiring harness.
machine ECM (WP 0052 00).
(b) Battery disconnect switch and engine 2. If one or more resistance
start switch remain in OFF position
measurements is not correct, there is a
short in wiring harness. Short is
(c) At sender wiring harness connector,
between signal contact J1-22 (wire 447
measure resistance between signal
PK) and circuit with low resistance
contact 1 (wire 447 PK) and all contacts
measurement. Replace wiring harness
used in ECM wiring harness connector.
in question (WP 0169 00 thru WP 0175
00).
0096 04
427-B1853
1. Check sender.
1. If diagnostic code changed from CID
Disconnect wiring harness from sender (WP
0096 FMI 04 to CID 0096 FMI 03, this
0177 00).
indicates failure is no longer present.
Replace fuel sending unit (WP 0177
00).
2. If diagnostic code remains, go to Test 2.