TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
2. Check autoshift switch circuits for a short 1. If each resistance measurement is
0368 04 -
to ground.
greater than 5,000 Ohms, go to Test 3.
Cont.
(a) Wiring harness connector(s) remains 2. If one or more measurement is less than
disconnected from ECM.
5.0 Ohms, there is a short in wiring
(b) Battery disconnect switch and engine
harness between wire 977 YL and
start switch remain in OFF position
circuit with lowest resistance
measurement, wire 973 BR and circuit
(c) Disconnect contacts 1, 4, and 5 from
with lowest resistance measurement, or
autoshift switch.
wire M998 OR and circuit with lowest
(d) At ECM wiring harness connector,
resistance measurement. Replace
measure resistance from contact J1-26
wiring harness in question (WP 0169
(wire 977 YL), contact J1-27 (wire 973
00 thru WP 0175 00).
BR), and contact J1-28 (wire M998
OR) of wiring harness to all contacts
used in ECM wiring harness
connectors.
3. Check autoshift switch circuits in harness. 1. If each resistance measurement is less
(a) Wiring harness remains disconnected
than 5.0 Ohms, go to Test 4.
from ECM and switch.
2. If one of resistance measurements is
(b) At switch harness connector, connect a
greater than 5,000 Ohms, circuit is
jumper wire between contact 1 (wire
open. Replace wiring harness in
973 BR) and contact 4 (wire 977 YL).
question (WP 0169 00 thru WP 0175
(c) At ECM harness connector, measure
00).
resistance from contact J1-27 (wire 973
BR) to contact J1-26 (wire 977 YL).
(d) At switch harness connector, connect a
jumper wire between contact 6 (wire
M998 OR) and contact 4 (wire 977
YL).
(e) At ECM harness connector, measure
resistance from contact J1-28 (wire
M998 OR) to contact J1-26 (wire 977
YL).
0009 00-46
