TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
2. Check autoshift switch circuits for a short 1. If each resistance measurement is
0368 03 -
to +battery circuit.
greater than 5,000 Ohms, go to Test 3.
Cont.
(a) Wiring harness connector(s) remains 2. If one or more measurements is less
disconnected from ECM.
than 5.0 Ohms, short is between wire
(b) Battery disconnect switch and engine
977 YL and circuit with lowest
start switch remain in OFF position
resistance measurement, wire 973 BR
and circuit with lowest resistance
(c) Disconnect following contacts from
measurement, or wire M998 OR and
Auto/Manual/VSC switch: 1, 4, and 5.
circuit with lowest resistance
(d) At ECM wiring harness connector,
measurement. Replace wiring harness
measure resistance from contact J1-26
in question (WP 0169 00 thru WP 0175
(wire 977 YL), contact J1-27 (wire 973
00).
BR), and contact J1-28 (wire M998
OR) of wiring harness to all contacts
used in ECM wiring harness
connectors.
3. Check autoshift switch circuits in harness. 1. If each resistance measurement is less
(a) Wiring harness remains disconnected
than 5.0 Ohms, go to Test 4.
from ECM and switch.
2. If one resistance measurement is
(b) At switch harness connector, connect a
greater than 5,000 Ohms, circuit is
jumper wire between contact 1 (wire
open. Replace wiring harness in
973 BR) and contact 4 (wire 977 YL).
question (WP 0169 00 thru WP 0175
(c) At ECM harness connector, measure
00).
resistance from contact J1-27 (wire 973
BR) to contact J1-26 (wire 977 YL).
(d) At switch harness connector, connect a
jumper wire between contact 6 (wire
M998 OR) and contact 4 (wire 977
YL).
(e) At ECM harness connector, measure
resistance from contact J1-28 (wire
M998 OR) to contact J1-26 (wire 977
YL).
0009 00-43
