TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0426 03
427-B1859
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear diagnostic codes when original diagnostic code has been
corrected. Ensure diagnostic code CID 0426 FMI 03 is active before performing
this procedure.
1. Check for power at sensor.
1. If voltage is 5V, go to Test 2.
(a) Do not disconnect harness connector
2. If voltage is not 5V, replace wiring
from sensor.
harness in question (WP 0169 00 thru
(b) Turn engine start switch and battery
WP 0175 00).
disconnect switch to ON position (TM
(c) At back of harness connector for all
sensors, insert multimeter probe along
voltage supply wire (contact A).
(d) Measure voltage from contact A to
frame ground.