TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0585 02
427-B1866
1. Check sensor case resistance.
1. If resistance is greater than 10,000
(a) Turn engine start switch and battery
Ohms, go to Test 2.
disconnect switch (if equipped) to OFF 2. If resistance is not greater than 10,000
position (TM 5-3805-290-10).
Ohms, replace transmission output
(b) Disconnect wiring harness connector
speed sensor No. 1 (WP 0069 00).
from transmission output speed sensor
No. 1 (WP 0069 00).
(c) Measure resistance from contact 1
(wire E901 GN) and contact 2 (wire
E900 WH) to sensor case.
1. If resistance is approximately 1,075
2. Check sensor resistance.
Ohms, go to Test 3.
(a) Wiring harness connector remains
2. If resistance is not approximately 1,075
disconnected.
Ohms, replace transmission output
(b) Measure resistance between contact 1
speed sensor No. 1 (WP 0069 00).
(wire E901 GN) and contact 2 (wire
E900 WH) of sensor connector.