TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1. If resistance is greater than 5,000
3. Check for shorts to ground.
0590 09 -
Ohms, go to Test 4.
(a) Battery disconnect switch remains in
Cont.
2. If resistance is less than 5,000 Ohms,
OFF position (TM 5-3805-290-10).
there is a short between frame ground
(b) Disconnect wiring harness connectors
and contacts J2-67 (wire F711 GN) and
from all ECMs that use CAN data link
J2-68 (wire F712 GY) of CAN data link
(WP 0048 00, WP 0049 00, WP 0052
circuit in wiring harness. Replace
00, and WP 0053 00).
wiring harness in question (WP 0169
(c) At machine ECM wiring harness,
00 thru WP 0175 00).
measure resistance between frame
ground and connector contacts J2-67
(wire F711 GN) and J2-68 (wire F712
GY) of CAN data link circuit.
1. If harness circuit resistance is correct,
4. Check for short to +battery circuit.
go to Test 5.
(a) Battery disconnect switch remains in
2. If resistance is less than 5,000 Ohms,
OFF position (TM 5-3805-290-10).
there is a short between +battery circuit
(b) All related ECMs remain disconnected
and contact J2-67 (wire F711 GN) or
from wiring harness.
contact J2-68 (wire F712 GY) of CAN
(c) At machine ECM wiring harness
data link circuit in wiring harness.
connector, perform Tests (d) and (e).
Replace wiring harness in question
(d) Measure resistance between connector
(WP 0169 00 thru WP 0175 00).
contact J1-31 (wire 126 RD) and
connector contact J2-67 (wire F711
GN).
(e) Measure resistance between connector
contact J1-31 (wire 126 RD) and
connector contact J2-68 (wire F712
GY).
5. Check for open circuit in harness.
1. If resistance is less than 5.0 Ohms, go
(a) Battery disconnect switch remains in
to Test 6.
OFF position (TM 5-3805-290-10).
2. If resistance is greater than 5.0 Ohms,
(b) All related ECMs remain disconnected
CAN data link circuit is open in wiring
from wiring harness.
harness. Replace wiring harness in
(c) Check resistance of CAN data link
question (WP 0169 00 thru WP 0175
circuit in wiring harness by performing
00).
Tests (d) and (e).
(d) Measure resistance between connector
contact J2-68 (wire F712 GY) of
implement ECM and connector contact
61 of engine ECM.
(e) Measure resistance between connector
contact J2-67 (wire F711 GN) of
implement ECM and connector contact
52 of engine ECM.
0009 00-73
