TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
6. Check for additional diagnostic codes for
1. If diagnostic codes are not present for
0590 09 -
other ECMs.
other ECMs, replace engine ECM (WP
Cont.
(a) Turn engine start switch and battery
0053 00).
disconnect switch to OFF position (TM 2. If diagnostic codes are present for other
ECMs, replace machine ECM (WP
(b) One at a time, reconnect ECMs that use
0052 00).
CAN data link (WP 0048 00, WP 0049
00, WP 0052 00, and WP 0053 00).
(c) Turn battery disconnect switch and
engine start switch to ON position (TM
(d) After each ECM has been reconnected,
check for diagnostic codes logged
against that ECM.
0600 03
427-B1867
1. Check control and harness.
1. If voltage is between 4.5 and 8.0 DCV,
(a) Turn battery disconnect switch and
replace hydraulic oil temperature
engine start switch to ON position (TM
sensor (WP 0070 00).
2. If voltage is not between 4.5 and 8.0
(b) Disconnect wiring harness connector
DCV, go to Test 2.
from hydraulic oil temperature sensor
(WP 0070 00).
(c) At hydraulic oil temperature sensor
wiring harness connector, measure
voltage (DCV) between signal contact
1 (wire 442 GY) and return contact 2
(wire 202 BK).