TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0673 02
427-B1871
1. Check sensor case resistance.
1. If resistance is greater than 10,000
(a) Turn engine start switch and battery
Ohms, go to Test 2.
disconnect switch to OFF position (TM 2. If resistance is not greater than 10,000
Ohms, replace transmission output
(b) Disconnect wiring harness connector
speed sensor No. 2 (WP 0069 00).
from transmission output speed sensor
No. 2 (WP 0069 00).
(c) Measure resistance from contact 1
(wire E907 GY) and contact 2 (wire
E906 OR) to sensor case.
2. Check sensor resistance.
1. If resistance is approximately 1,075
(a) Wiring harness connector remains
Ohms, go to Test 3.
disconnected (TM 5-3805-290-10).
2. If resistance is not approximately 1,075
(b) Measure resistance between contact 1
Ohms, replace transmission output
(wire E907 GY) and contact 2 (wire
speed sensor No. 2 (WP 0069 00).
E906 OR) of sensor connector.