TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1403 03
427-B1882
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 1403 FMI 03 is active before per-
forming this procedure.
1. Check clutch 3 (reverse) solenoid energize 1. If each resistance measurement is
greater than 5,000 Ohms, go to Test 2.
circuit for a short to +battery circuit.
2. If each resistance measurement is not
(a) Turn engine start switch and battery
greater than 5,000 Ohms, there is a
disconnect switch to OFF position (TM
short between J1-66 (754 BU) and
circuit with low resistance
(b) Disconnect wiring harness connectors
measurement. Replace wiring harness
from clutch 3 (reverse) solenoid (WP
in question (WP 0169 00 thru WP 0175
0177 00) and machine ECM (WP 0052
00).
00).
(c) At ECM wiring harness connector,
measure resistance from contact J1-66
(wire 754 BU) to all contacts used in
ECM wiring harness connectors.