TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1403 05
427-B1882
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 1403 FMI 05 is active before per-
forming this procedure.
1. If diagnostic code remains active, go to
1. Check clutch 3 (reverse) solenoid.
Test 2.
(a) Turn battery disconnect switch and
engine start switch to ON position. Do 2. If diagnostic code is no longer active,
clutch 3 (reverse) solenoid has failed.
not start engine.
Repeat this test to verify clutch 3
(b) Disconnect clutch 3 (reverse) solenoid
(reverse) solenoid failure. Replace
(WP 0177 00) from wiring harness.
modulating valve (WP 0177 00).
(c) At clutch 3 (reverse) solenoid wiring
Verify new transmission control valve
harness connector, place a jumper wire
corrects problem.
from contact 1 (wire 754 BU) to contact
2 (wire X750 OR).
(d) Connect MSD (WP 0006 00) and
observe status of CID 1403 FMI 05.