TM 5-3805-290-23-1
TRANSMISSION TESTS, INSPECTIONS, AND ADJUSTMENTS - CONTINUED
0014 00
TRANSMISSION CLUTCH FILL CALIBRATION - CONTINUED
N OT E
To obtain correct calibration of modulating valves, hydraulic implement controls should not be oper-
ated during calibration procedure.
When calibration has been performed on all clutches, dialog box will display results for each clutch.
There are only two possible results: "Success" and "At a limit".
3.
Press "Next" button to start calibration. If conditions for setup are not correct, condition that is not correct will display in
middle display area. Calibration will not start. When conditions are correct, press "Next" button to start fill calibration.
427-B0922
0014 00-7