TM 5-3805-290-23-1
TRANSMISSION TESTS, INSPECTIONS, AND ADJUSTMENTS - CONTINUED
0014 00
TRANSMISSION CLUTCH FILL CALIBRATION - CONTINUED
4.
Calibration procedure continues until ECM determines one step is not met. Middle display area will display message to
alert personnel of error. Personnel can correct error described in middle display area, or calibration can be cancelled by
pressing "Cancel" button. MSD will display message in middle display area to alert personnel of problem.
5.
Calibration procedure could be stopped for several reasons. Refer to Table 2 for error codes that can be displayed by
MSD. When condition that caused error code has been corrected, restart calibration.
Table 2. Error Codes for Transmission Clutch Fill Calibration.
Error Code
Description
Procedure
0002
Active diagnostic present
There is active diagnostic code. Exit calibration and
correct condition that caused diagnostic code.
0006
Aborted by user
Calibration has been stopped by user. Restart
calibration procedure.
0009
Aborted by ECM
Calibration has been stopped by ECM. Restart
calibration procedure.
1012
Engine rpm incorrect
Engine rpm is not correct. Set engine rpm to high idle.
1018
Parking brake not engaged
Parking brake is not engaged. Set parking brake.
101B
Machine speed not zero
Machine ECM detects machine movement. Machine
must not move during calibration.
1001F
Direction lever not in NEUTRAL
Transmission direction and shift lever is not in
NEUTRAL. Place transmission direction and shift
lever in NEUTRAL.
1021
Transmission oil temperature too low
Transmission oil temperature is too low. Repeat
procedure to increase hydraulic oil temperature.
1022
Transmission oil temperature too high
Transmission oil temperature is too high. Decrease
engine speed and ensure engine access doors are
closed.
0014 00-8
