TM 5-3805-290-23-2
BOOST PRESSURE SENSOR REPLACEMENT - CONTINUED
0065 00
REMOVAL
1.
Release red positive lock tab (1) from wiring harness (2).
2.
Disconnect wiring harness (2) from boost pressure sensor (3).
3.
Remove boost pressure sensor (3) from inlet (4).
4.
Remove and discard O-ring (5) from boost pressure sensor (3).
427-B1101
INSTALLATION
1.
Install new O-ring (5) on boost pressure sensor (3) and install assembly in inlet (4). Tighten sensor to 7 lb-ft
(9.5 Nm).
2.
Connect wiring harness (2) and lock red positive lock tab (1).
3.
Run engine and check for vacuum leaks (TM 5-3805-290-10).
END OF WORK PACKAGE
0065 00-2
