2
TM 5-3805-290-23-2
ENGINE OIL PRESSURE SENSOR REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Personnel Required
Maintenance Level
Unit
MOS 62B, Construction Equipment Repairer
Tools and Special Tools
Equipment Conditions
Tool kit, general mechanic's (Item 96, WP 0205 00)
Machine parked on level ground (TM 5-3805-290-
Shop equipment, common no. 1 (Item 77, WP 0205
10)
Work tool lowered to ground (TM 5-3805-290-10)
Wrench, torque (Item 102, WP 0205 00)
Parking brake engaged (TM 5-3805-290-10)
Materials/Parts
Wheels chocked
Cap set, protective (Item 8, WP 0206 00)
Oil, lubricating, OEA-30, Arctic (Item 32, WP
Battery disconnect switch in OFF position (TM 5-
3805-290-10)
Oil, lubricating, OE/HDO-5/40 (Item 34, WP 0206
Drawings Required
Oil, lubricating, OE/HDO-15/40 (Item 35, WP
TM 5-3805-290-23P, Figure 51
Estimated Time to Complete Task
Rag, wiping (Item 41, WP 0206 00)
O-ring
1.0 hr
WARN I N G
Ensure battery disconnect switch is in OFF position before performing this task. Failure to follow this warn-
ing may result in injury to personnel or damage to equipment.
To prevent injury to personnel, wear protective eye covering and gloves.
C AU T I O N
Wipe area clean around sensor during removal. Plug opening after removing. Contamination of system
could result in premature failure.
N OT E
Use a container to catch any fluid that may drain from hoses or system. Dispose of fluid IAW local policy
and ordinances. Ensure all spills are cleaned up.