2
TM 5-3805-290-23-2
TORQUE CONVERTER AND TRANSMISSION OIL TEMPERATURE SENSORS REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Maintenance Level
Materials/Parts - Continued
Unit
Rag, wiping (Item 41, WP 0206 00)
O-ring
Tools and Special Tools
Tool kit, general mechanic's (Item 96, WP 0205 00)
Personnel Required
Shop equipment, common no. 1 (Item 77, WP 0205
MOS 62B, Construction Equipment Repairer
Wrench, torque (Item 102, WP 0205 00)
Equipment Conditions
Right-side covers beneath cab behind ladder
Materials/Parts
removed (WP 0107 00)
Cap set, protective (Item 8, WP 0206 00)
Drawings Required
Oil, lubricating, OEA-30, Arctic (Item 32, WP
TM 5-3805-290-23P, Figure 51
Oil, lubricating, OE/HDO-40 (Item 33, WP 0206
Estimated Time to Complete Task
1.0 hr
Oil, lubricating, TO-4 (Item 36, WP 0206 00)
WARN I N G
Ensure battery disconnect switch is in OFF position before performing this task. Failure to follow this warn-
ing may result in injury to personnel or damage to equipment.
To prevent injury to personnel, wear protective eye covering and gloves.
C AU T I O N
Wipe area clean around sensor during removal. Plug opening after removing. Contamination of system
could result in premature failure.
N OT E
Use a container to catch any fluid that may drain from hoses or system. Dispose of fluid IAW local policy and
ordinances. Ensure all spills are cleaned up.
The following procedure is for the torque converter oil temperature sensor. The procedure for the transmis-
sion oil temperature sensor is identical.