TM 5-3805-291-10
Systems Operation Section
Table 1
Display Button Operation for Single Camera Systems
Procedure
Notes
Operation
Brightness Adjustment
Press button 5 in order to enable the
If "Auto Brightness "is enabled, the
"Brightness Adjustment", then press
brightness starting set point can be
either button 6 or 7 in order to adjust
changed by the operator while in the
the brightness.
manual or automatic mode.
Press any other display key in order to
exit brightness adjustment mode.
Press button 4 in order to enable the
Press any other display key in order to
Contrast Adjustment
Contrast Adjustment, then press either
exit the contrast adjustment mode.
button 6 or 7 in order to adjust the
contrast level.
Press button 2 in order to turn the
Automatic Brightness ON/OFF
When WAVS is placed in the "Automatic
automatic brightness option ON/OFF.
Brightness" mode, the display will
brighten or dim automatically as the
ambient light increases or decreases.
Press button 3 in order to turn the
Standby ON/OFF
If the standby mode is ON, the display
standby option ON/OFF.
will remain dark until a WAVS input
is detected, however, the power and
standby LED should remain on.
LED Indication
If the LED for button 8 and the LED of the camera that is selected (C1, C2, or C3) flash together, the image is switched off
because the ambient temperature is below 25 C (13F) or is above 70 C (158 F).
Multi Camera System
2. If the machine has a second camera, press button
1 (camera select) again in order to select the
next camera that is to be viewed and/or have its
Camera Select - for Multi Camera System
settings adjusted.
END OF WORK PACKAGE
3. If the machine has a third camera, press button
camera select function disabled. The camera
1 (camera select) again in order to select the
select function must be enabled for a multi
next camera that is to be viewed and/or have its
camera system.
settings adjusted.
With "Camera Select" enabled, individual cameras
Press and hold the camera select button for two
can be selected, configured, and positioned in order
seconds in order to exit the "Manual" mode.
to pride
the desired view.
Available Operator Selections for the
In order to enable "Camera Select":
WAVS Display
1. Press and hold button 1 (camera select) and
button 4 (contrast), simultaneously for 40 seconds.
The selections that are listed in this section have
This will enable the camera select option.
been made available to the operator of the machine.
The selections for the WAVS display can be changed
After "Camera Select" has been enabled, you will
by the operator as needed. Refer to table 2 and to
be able to press button 1 (camera select) in order
Illustration 7.
to place the system in "Manual" mode.
Brightness Adjustment
The LED that is above and to the right of button 1
(camera select) will flash in order to indicate that
The brightness adjustment option allows the operator
the system is in manual mode.
to vary the brightness of the view that is shown on
the display. If the brightness level is set to high and
One of the indicator LED's (C1, C2, or C3) that are
if the "Auto Brightness" is not enabled, then there is
to the left of the display buttons will indicate which
a possibly that in a well lit area the display would
camera view is displayed. Refer to Illustration 7
appear completely "white".
(9).
0004 00-73/(0004 00-74 Blank)
