TM 5-3805-291-10
Maintenance Section
Maintenance Interval Schedule
Maintenance Section
Adjust the spray nozzle within one inch of the
i02736179
camera lens in order for the camera wash system to
Display - Clean
perform proper operation. adjust the spray nozzle
within one inch of the camera lens. The angle of the
SMCS Code: 7347-070
spray nozzle should be between 30 degrees and 45
degrees from the lens of the camera.
In order to maintain sufcient vision, the display and
the camera lens may need to be cleaned periodically
Note: When you are adjusting, verify that the spray
due to the environment.
nozzle is not in the view of the camera.
Use a soft, damp cloth with water only in order to
The preferred method of adjustment would require
clean the display. The display has a soft plastic
two people:
surface that is easily damaged by any material that
is abrasive.
One person in the cab that is looking at the image
on the display
Note: The display is not sealed. The display can not
be immersed. The display can not have a pressure
One person that is making the adjustment on the
wash.
spray nozzle
i02736175
Camera - Clean
SMCS Code: 7348-070
Camera
If necessary, use a damp cloth in order to clean the
glass of the camera. The camera is sealed. The
camera is not affected by a wash with high pressure
spray.
The camera is equipped with an internal heater to
help counteract the following effects: condensation,
snow, and accumulation of ice.
Note: When you access the cameras for cleaning, be
sure to observe safe procedures for access. Maintain
a three-point contact and/or use a safety harness.
Note: Alternatively, cameras may be cleaned from
ground level by using a wash with a high pressure
spray or a damp rag on a wand.
Camera Wash System
The camera wash system is installed typically on the
rear facing camera for easy cleaning. The cleaning
is performed by pressing the switch for two second
durations until the camera is clean.
activating the camera wash system at the end of the
shift in order to clear the water and the debris. This
will ensure that the water and debris does not freeze
up the spray head.
0004 00-69
