TM 5-3805-291-10
Systems Operation Section
Manual Camera Selection
1. Press button 2 (Auto Brightness) and button 3
(Standby) simultaneously for 10 seconds in order
Manual mode is available only on WAVS
to turn the existing marker off.
multi-camera installations. That is, manual
mode is not available for WAVS single camera
2. Press button 2 (Auto Brightness) and button 3
installations.
(Standby) simultaneously for 10 seconds again in
order to turn the marker back on.
Automatic Brightness ON/OFF
3. Use button 6 (Minus) or button 7 (Plus) in order to
The Automatic Brightness ON/OFF option allows the
adjust marker position.
operator to set the display to change the brightness
level automatically. The WAVS display is equipped
4. Press any other button, other than button 6
with a sensor to detect ambient light. When WAVS
(Minus) or button 7 (Plus) in order to exit the
is placed in the "Automatic Brightness" mode, the
marker set option.
display will brighten or dim automatically as the
ambient light increases or decreases.
Switch Off Key Board
The brightness starting set point can be changed
The "Switch Off Key Board" option is provided in order
by the operator while in the manual or automatic
to restrict access to the WAVS settings. However,
mode. In order to change the set point, turn the auto
even if the key board is switched off, the display
brightness on and perform the brightness adjustment
will continue to be active. Therefore, if the WAVS
to the desired level for the starting point.
encounters any camera system inputs, the display
will show the view from the active input. However, any
Standby ON/OFF
other key board operations or functions are disabled.
Your single camera system installation may be
Press and hold button 1 (camera select) and button 5
configured with the "Standby" feature enabled or
(brightness) at the same time for 15 seconds in order
disabled. If "Standby" is enabled, the display will
to disable input from the key board.
remain dark unless the camera view has been
activated by machine operation or by the operator.
In order to enable the key board once again, press
and hold button 1 (camera select) and 5 (brightness)
"Standby" may be useful at times when the operator
at the same time for 15 seconds.
feels that the display image is not needed, such as
when travelling at night or when reverse will not be
Single Camera System
used.
Available Operator Selections for the
If "Standby" is disabled, the operator still has the
option to adjust the brightness and/or contrast if the
WAVS Display
display is on constantly.
The selections that are listed in this section have
been made available to the operator of the machine.
The selections for the WAVS display can be changed
by the operator as needed. Refer to table 1 and
Illustration 7.
Brightness Adjustment
The brightness adjustment option allows the operator
to vary the brightness of the view that is shown on
the display. If the brightness level is set to high and
if the "Auto Brightness" is not enabled, then there is
a possibly that in a well lit area the display would
appear completely "white".
Contrast Adjustment
The contrast adjustment option allows the operator
to vary the contrast of the view that is shown on the
display.
0004 00-72
