TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(d) Part number of Messenger.
1. If all part numbers are correct, go to Test
0562 02 - Continued.
2.
2. If all part numbers are not correct,
replace incorrect ECM with an ECM
that has correct part numbers. Flash
correct configuration software (WP
0056 00, WP 0057 00, WP 0060 00, and
WP 0063 00).
2. Inspect harness connections.
(a) Turn battery disconnect switch to OFF
position (TM 5-3805-291-10).
(b) Disconnect and inspect all harness
connections related to CAT Data Link
(WP 0237 00). Make sure connectors
are clean and tight. Refer to Electrical
Connectors Inspection as necessary
(c) Check connectors for proper mating.
(d) Check wires at connector.
(e) Check each wire for nicks or signs of
abrasion in the insulation.
(f) Check for moisture at connector.
(g) Check for dirty or corroded contacts.
(h) Check each pin and socket of wiring
harness connectors.
(i) Reconnect all connectors.
1. If wiring harness connectors are tightly
connected and free of corrosion, go to
Test 3.
2. If wiring harness connectors are in need
of repair, replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
3. Check for shorts to ground.
(a) Battery disconnect switch remains in
OFF position (TM 5-3805-291-10).
(b) Disconnect wiring harness from all
ECMs that use CAT Data Link (WP
0056 00, WP 0057 00, WP 0060 00, and
WP 0063 00).
0009 00-29