TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(c) Turn battery disconnect and engine
0562 09 - Continued.
start switches to ON position (TM 5-
3805-291-10).
(d) At connector J1, measure voltage from 1. If voltage is correct, go to Test 3.
+battery terminals to negative battery 2. If voltage does not measure 18 to 35
terminals.
DCV, ensure that proper ground is
available. If ground is correct, repair
power circuit. Also, check circuit
breakers (WP 0195 00 thru WP 0201
00).
3. If conditions are not resolved, go to Test
3.
3. Check CAT Data Link circuit for a short to
ground.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Disconnect and inspect wiring harness
connectors related to circuits of CAT
Data Link (WP 0237 00). Ensure
connector contacts are clean and tight.
Refer to Electrical Connectors
Inspection (WP 0022 00) as necessary.
(c) Disconnect wiring harness from all
modules (WP 0056 00, WP 0057 00,
WP 0060 00, and WP 0063 00).
(d) At wiring harness for powertrain ECM, 1. If resistance measurement is correct, go
measure resistance from contact J1-20
to Test 4.
(wire 945-BR) and contact J1-10 (wire 2. If resistance measurement is not correct,
944-OR) to all possible sources of
short is between J1-20 (wire 945-BR)
ground.
and circuit with low resistance
measurement, or short is between J1-10
(wire 944-OR) and circuit with low
resistance measurement.
3. Replace wiring harness in question (WP
0195 00 thru WP 0201 00). If conditions
are not resolved, replace ECM
powertrain (WP 0063 00).
4. If problem remains, exit this procedure
and repeat.
0009 00-33