TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check harness for an open circuit.
0444 05 - Continued.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Disconnect wiring harness
connector(s) from powertrain ECM
(WP 0063 00).
(c) Jumper wire installed in previous Test
1 remains in place.
1. If resistance is less than 5.0 Ohms, go to
(d) At wiring harness connector, measure
Test 3.
resistance from signal contact J2-7
(wire 306-GN) to contact J2-8 (wire
2. If resistance is greater than 5,000 Ohms,
P990-BR).
open circuit is in wire 306-GN or in wire
P990-BR of wiring harness. Replace
wiring harness in question (WP 0195 00
thru WP 0201 00).
3. Check if diagnostic code remains active.
(a) Inspect harness connector contacts and
clean harness connectors.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Use messenger to check status of CID
1. If CID 0444 FMI 05 is active, exit this
044 FMI 05.
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 0444 FMI 05 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
0009 00-25