TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(c) At wiring harness connector for sensor, 1. If voltage measurement is
0737 03 - Continued.
measure voltage from contact 1 (wire
approximately battery voltage, go to
126-PK) to ground.
Test 3.
2. If voltage measurement is not
approximately battery voltage, supply
circuit is not correct. Replace wiring
harness in question (WP 0195 00 thru
WP 0201 00).
3. Check for an open circuit in the return circuit.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Sensor remains disconnected from
wiring harness.
(c) Disconnect wiring harness connectors
from powertrain ECM.
(d) At wiring harness connector for sensor, 1. If resistance measurement is less than
measure resistance from contact 2
5,000 Ohms, recheck status of
(wire C216-BK) to ground.
diagnostic code. If diagnostic code
remains present, exit this procedure and
repeat this procedure. If cause of
diagnostic code is not found, replace
powertrain ECM.
2. If resistance measured is not correct,
open circuit is in return circuit with high
resistance measurement. Replace
wiring harness in question (WP 0195 00
thru WP 0201 00).
4. Check for an open circuit in signal circuit.
(a) Engine start and battery disconnect
switches remain in OFF position (TM
5-3805-291-10).
(b) Wiring harness connectors remain
disconnected from ECM.
(c) At wiring harness connector for sensor,
install a jumper wire from contact 3
(wire G746-WH) to ground.
0009 00-71
