TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(b) Use messenger to check status of CID
0702 03 - Continued.
0702 FMI 03 while activating and
deactivating each position of shift
lever. Note results (TM 5-3805-291-
10).
N OT E
If code does not remain active during operation of lever, this could indi-
cate a possible open circuit (which corresponds to lever position) in wir-
ing harness.
(c) Turn battery disconnect and engine
start switches to OFF position (TM 5-
3805-291-10).
(d) Disconnect wiring harness connectors
from the powertrain ECM (WP 0063
00).
(e) At wiring harness connector for
1. If continuity checks do not agree with
powertrain ECM, check continuity to
schematic, go to Test 2.
ground of open contacts and grounded
2. If continuity checks agree with the
contact for each position of
schematic, go to Test 3.
transmission shift lever. Activate and
deactivate each position of
transmission shift lever.
2. Check switch.
(a) Battery disconnect and engine start
switches remain in OFF position (TM
5-3805-291-10).
(b) Wiring harness connectors remain
disconnected from powertrain ECM.
(c) Disconnect wiring harness from
transmission shift lever (WP 0101 00).
(d) Check continuity to ground of open
1. If continuity checks do not agree with
contacts and grounded contact for each
schematic, replace shift lever (WP 0101
position of transmission shift lever.
00).
Activate and deactivate each position 2. If continuity checks agree with
of transmission shift lever.
schematic, replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
0009 00-69
