TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(b) Check continuity to ground of open
1. If continuity checks do not agree with
0702 02 - Continued.
contacts and grounded contact for each
ground and open combinations, replace
position of transmission shift lever.
shift lever (WP 0101 00).
Activate and deactivate each position 2. If continuity checks agree with
of transmission shift lever.
schematic, replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
3. Check for short to +battery.
1. If continuity exists between one source
At wiring harness connector for powertrain
of battery voltage, wiring harness is
ECM, check continuity from each switch
faulty. Replace wiring harness in
contact to contacts J1-31, J1-39, and J2-47.
question (WP 0195 00 thru WP 0201
00).
2. If continuity does not exist between one
of source of battery voltage and switch
circuit, exit this procedure and repeat
these procedures. If cause is not found,
replace powertrain ECM (WP 0063 00).
0702 03
427-C1628
N OT E
Ensure diagnostic code CID 0702 FMI 03 is active before performing this proce-
dure.
The following procedure can create other fa lts that can be detected by powertrain
u
ECM. Ignore created faults and clear created faults when original diagnostic code
is corrected.
1. Check for an open circuit.
(a) Operate machine (TM 5-3805-291-
10).