TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
3. Check for short to +battery.
1. If continuity exists between one source
0702 03 - Continued.
At wiring harness connector for powertrain
battery voltage and switch circuit,
ECM, check continuity from each switch
wiring harness is faulty. Replace wiring
contact to all sources of battery voltage.
harness in question (WP 0195 00 thru
WP 0201 00).
2. If continuity does not exist between one
source of battery voltage and switch
circuit, exit this procedure and repeat
procedures. If cause is not found,
replace powertrain ECM (WP 0063 00).
0737 03
427-C1629
N OT E
The following test procedure may create other diagnostic codes. Ignore
these created diagnostic codes and clear the diagnostic codes when the
original diagnostic code is corrected. Ensure diagnostic code CID 0737
FMI 03 is active before performing this procedure.
1. Check voltage at sensor.
(a) Turn battery disconnect and engine
start switches to ON position (TM 5-
3805-291-10).
(b) Disconnect brake pedal position sensor
from wiring harness (WP 0075 00).
(c) At wiring harness connector for sensor, 1. If voltage is approximately battery
voltage, go to Test 4.
measure voltage between contact 1
(wire 126-PK) and contact 2 (wire
2. If voltage is not approximately battery
C216-BK).
voltage, go to Test 2.
2. Check for an open circuit in supply circuit.
(a) Engine start and battery disconnect
switches remain in ON position (TM 5-
3805-291-10).
(b) Sensor remains disconnected from
wiring harness.