TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2. If diagnostic code is not present,
0673 02 - Continued.
diagnostic code does not exist at this
time. Resume normal machine
operation.
N OT E
Adjusting speed sensor requires removal of transmission.
5. Check sensor adjustment.
(a) Check speed sensor 2 adjustment (WP
0093 00).
(b) Repeat Test 4. Check whether CID
1. If diagnostic code remains present,
0673 FMI 02 diagnostic code is
replace speed sensor 2. Go to Test 6.
present.
2. If diagnostic code is not present,
adjusting speed sensor 2 has corrected
failure.
6. Check if diagnostic code is still present.
(a) Remove connectors J1 and J2 from
powertrain ECM. Inspect and clean
wiring harness connector contacts (WP
0063 00).
(b) Reconnect all wiring harness
connectors.
(c) Engine start and battery disconnect
switches remain in ON position (TM 5-
3805-291-10).
(d) Use messenger to clear all inactive
diagnostic codes (TM 5-3805-291-10).
(e) Operate machine (TM 5-3805-291-
10).
(f) Use messenger to check if diagnostic
1. If diagnostic code has not been
code is present (TM 5-3805-291-10).
corrected, perform test for diagnostic
code again. If cause of diagnostic code
is not found, replace powertrain ECM
(WP 0063 00).
2. If diagnostic code is not present,
diagnostic code does not exist at this
time. Resume normal machine
operation.
0009 00-66
