TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(g) Disconnect multimeter lead from
0794 03 - Continued.
contact B (wire C216-BK) and connect
lead to contact C (wire 416-OR).
(h) Measure resistance between contact A
1. If resistance from contact A to contact
(wire C216-BK) and contact C (wire
B is less than 5 Ohms and resistance
416-OR).
from contact A to contact C is greater
than 5,000 Ohms, go to Test 6.
2. If resistance from contact A to contact
B is not less than 5 Ohms, or resistance
from contact A to contact C is not
greater than 5,000 Ohms, replace
secondary steering oil pressure switch
(WP 0088 00).
6. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Use messenger to check status of CID
1. If CID 0794 FMI 03 is active, exit this
0794 FMI 03 (TM 5-3805-291-10).
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 0794 FMI 03 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
0009 00-84
