TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(d) At wiring harness connector for ECM, 1. If each resistance measurement is
0794 04 - Continued.
measure resistance from contact J2-61
greater than 5,000 Ohms, exit this
(wire 416-OR) and contact J2-60 (wire
procedure and repeat procedure. If
453-PK) of wiring harness to all
cause of diagnostic code is not found,
contacts used in wiring harness
replace powertrain ECM (WP 0063 00).
connectors for ECM.
2. If one or more measurements were less
than 5 Ohms, short is between (wire
453-PK) and circuit with lowest
resistance measurement, or short is
between (wire 416-OR) and circuit with
lowest resistance measurement.
Replace wiring harness in question (WP
0195 00 thru WP 0201 00).
3. Check switch operation (low pressure).
(a) Engine start and battery disconnect
switches remain in OFF position (TM
5-3805-291-10).
(b) Wiring harness remains disconnected
from ECM and switch.
(c) Connect one lead from a multimeter to
contact A (wire C216-BK) of
connector on switch.
(d) Connect other lead from a multimeter
to contact B (wire 453-PK) of
connector on switch.
(e) Measure resistance between contact A
(wire C216-BK) and contact B (wire
453-PK). Note resistance.
(f) Disconnect multimeter lead from
contact B (wire 453-PK) and connect
lead to contact C (wire 416-OR).
(g) Measure resistance between contact A
1. If resistance from contact A to contact
(wire C216-BK) and contact C (wire
C is less than 5 Ohms and resistance
416-OR).
from contact A to contact B is greater
than 5,000 Ohms, go to Test 4.
2. If resistance from contact A to contact
C is not less than 5 Ohms or resistance
from contact A to contact B is not
greater than 5,000 Ohms, replace
secondary steering oil pressure switch
(WP 0088 00).
0009 00-86
