TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
4. Check switch operation (high pressure).
0794 04 - Continued.
(a) Turn engine start and battery
disconnect switches to ON position
(TM 5-3805-291-10).
(b) Wiring harness remains disconnected
from ECM and switch.
(c) Press secondary steering pressure
switch to build up secondary steering
pressure (TM 5-3805-291-10).
(d) Connect one lead from a multimeter to
contact A (wire C216-BK) of the
connector on switch.
(e) Connect other lead from a multimeter
to contact B (wire 453-PK) of
connector on switch.
(f) Measure resistance between contact A
(wire C216-BK) and contact B (wire
453-PK). Note resistance.
(g) Disconnect multimeter lead from
contact B (wire 453-PK) and connect
lead to contact C (wire 416-OR).
1. If resistance from contact A to contact
(h) Measure resistance between contact A
B is less than 5 Ohms and resistance
(wire C216-BK) and contact C (wire
from contact A to contact C is greater
416-OR).
than 5,000 Ohms, go to Test 5.
2. If resistance from contact A to contact
B is not less than 5 Ohms or resistance
from contact A to contact C is not
greater than 5,000 Ohms, replace
secondary steering oil pressure switch
(WP 0088 00).
5. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate the machine (TM 5-3805-291-
10).
0009 00-87