TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(c) At wiring harness connector for ECM, 1. If each resistance measurement is
0794 03 - Continued.
measure resistance from contact J2-61
greater than 5,000 Ohms, go to Test 3.
(wire 416-OR) and contact J2-60 (wire 2. If one or more of measurements were
453-PK) to all contacts used in wiring
less than 5 Ohms, short is between (wire
harness connectors for ECM.
416-OR) and circuit with lowest
resistance measurement, or short is
between (wire 453-PK) and the circuit
with the lowest resistance measurement.
Replace wiring harness in question (WP
0195 00 thru WP 0201 00).
3. Check switch circuits in wiring harness.
(a) Wiring harness remains disconnected
from ECM and switch.
(b) Battery disconnect and engine start
switches remain in OFF position (TM
5-3805-291-10).
(c) At wiring harness connector for switch,
connect a jumper wire between contact
C (wire 416-OR) and contact B (wire
453-PK).
(d) At wiring harness connector for ECM,
1. If resistance is less than 5 Ohms, go to
measure resistance from contact J2-61
Test 4.
(wire 416-OR) to contact J2-60 (wire
2. If resistance is greater than 5,000 Ohms,
453-PK).
circuit is open. Replace wiring harness
in question (WP 0195 00 thru WP 0201
00).
4. Check switch operation (low pressure).
(a) Wiring harness remains disconnected
from ECM and switch.
(b) Battery disconnect and engine start
switches remain in OFF position (TM
5-3805-291-10).
(c) Remove jumper installed in Test 3.
0009 00-82
