TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
4. Check relay at secondary steering motor.
0795 07 - Continued.
(a) Battery disconnect switch remains ON
and engine remains OFF (TM 5-3805-
291-10).
(b) At relay by secondary steering motor,
connect a jumper wire from +battery to
wire 727-GN.
1. If relay energizes and secondary
(c) At relay by secondary steering motor,
steering motor turns ON, go to Test 5.
connect a jumper wire from -battery to
wire 200-BK.
2. If relay does not energize and secondary
steering motor does not turn ON, replace
secondary steering relay (WP 0053 00).
5. Check wire from ECM to relay on secondary
steering motor.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Disconnect wiring harness connector
J2 from powertrain ECM (WP 0063
00).
(c) Connect one lead from a multimeter to
wire 727-GN at relay by secondary
steering motor.
(d) At wiring harness connector J2,
connect the other lead from multimeter
to contact J2-9.
(e) Measure resistance of wire 727-GN
1. If resistance is less than 5 Ohms, go to
from the ECM to relay.
Test 6.
2. If resistance is greater than 5 Ohms, wire
has failed. Replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
6. Check ground circuit of relay at secondary
steering motor.
(a) Battery disconnect switch remains in
OFF position (TM 5-3805-291-10).
(b) At relay by secondary steering motor,
connect one lead from a multimeter to
terminal for wire 200-BK.
0009 00-92