TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
Turn engine start switch to ON
1. If secondary steering light illuminates
0795 07 - Continued.
position. Wait for instrument cluster
and wheel can be turned, operate
self-test to complete. Then, secondary
machine and check for a recurrence of
steering system performs a self-test.
diagnostic code.
For 3 seconds, secondary steering light 2. If secondary steering light does not
should illuminate and wheel can be
illuminate and wheel will not turn
turned (TM 5-3805-291-10).
during self-test, go to Test 2.
3. If secondary steering light does not
illuminate but wheel does turn during
self-test, troubleshoot secondary
steering pressure switch.
4. If secondary steering light illuminates
but wheel does not turn during self-test,
troubleshoot secondary steering
pressure switch.
2. Check secondary steering motor cables.
(a) Turn battery disconnect switch to ON
position (TM 5-3805-291-10).
(b) At secondary steering motor, check
1. If cables are properly connected and not
black ground cable. Check red power
damaged, go to Test 3.
cable that connects other side of relay 2. If cables are improperly connected or
to starter +battery terminal. Check red
damaged, replace cables (WP 0123 00).
power cable that connects other side of
relay to secondary steering motor.
3. Check secondary steering motor.
(a) Battery disconnect switch remains ON
and engine remains OFF (TM 5-3805-
291-10).
(b) At secondary steering motor, connect a
jumper cable from -battery to -battery
terminal of motor.
(c) At secondary steering motor, briefly
1. If secondary steering motor turns
connect a jumper cable from +battery
normally, go to Test 4.
to motor +battery terminal.
2. If secondary steering motor does not
turn normally, replace secondary
steering motor (WP 0123 00).
0009 00-91
