TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(c) Operate machine (TM 5-3805-291-
1403 05 - Continued.
10).
1. If CID 1403 FMI 05 is active, exit this
(d) Use messenger to check status of CID
1403 FMI 05 (TM 5-3805-291-10).
procedure and repeat this procedure. If
the cause of diagnostic code is not
found, replace powertrain ECM (WP
0063 00).
2. If CID 1403 FMI 05 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
1403 06
427-C1636
N OT E
The following test procedure may create other diagnostic codes. Ignore
these created diagnostic codes and clear these diagnostic codes when
original diagnostic code is corrected. Ensure diagnostic code CID 1403
FMI 06 is active before performing this procedure.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position. Do not
start engine (TM 5-3805-291-10).
(b) Connect MSD (WP 0005 00) and
observe status of diagnostic code.
(c) Disconnect solenoid with active
1. If CID 1403 FMI 06 changes to CID
diagnostic code from wiring harness
1403 FMI 05 when solenoid is
(WP 0203 00).
disconnected, repeat this test to verify
solenoid failure. Replace modulating
valve with active code (WP 0203 00).
Verify new solenoid corrects problem.
2. If CID 1403 FMI 06 remains active, go
to Test 2.
