TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2. If CID 1406 FMI 13 is not active,
1406 13 - Continued.
resume normal machine operation.
1521 02
427-C1640
N OT E
Ensure diagnostic code CID 1521 FMI 02 is active before performing this procedure.
Refer to Table 10, Status for Kickout Set Switch.
The following procedure can create other faults that can be detected by powertrain
ECM. Ignore these created faults and clear created faults when fault is corrected.
1. Check for an open circuit.
(a) Operate machine (TM 5-3805-291-
10).
(b) Connect MSD (WP 0005 00) and check
status of the CID 1521 FMI 02 while
activating and deactivating each
position of autoshift switch. Note
results
N OT E
If the code does NOT remain active during operation of the switch, this
could indicate a possible open circuit (which corresponds to the switch
position) in the wiring harness.
(c) Turn battery disconnect and engine
start switches to OFF position (TM 5-
3805- 291-10).
(d) Disconnect wiring harness connectors
from powertrain ECM (WP 0063 00).
