TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check if diagnostic code remains active.
1406 03 - Continued.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Use messenger to determine if CID
1. If CID 1406 FMI 03 is active, exit this
1406 FMI 03 is active (TM 5-3805-
procedure and repeat this procedure. If
291-10).
the cause of the diagnostic code is not
found, replace the powertrain ECM
(WP 0063 00).
2. If CID 1406 FMI 03 is not active,
resume normal machine operation.
1406 05
427-C1639
N OT E
The following test procedure may create other diagnostic codes. Ignore
these created diagnostic codes and clear these diagnostic codes when
original diagnostic code is corrected. Ensure diagnostic code CID 1406
FMI 05 is active before performing this procedure.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position. Do not
start engine (TM 5-3805-291-10).
(b) Disconnect solenoid with active
diagnostic code from wiring harness
(WP 0203 00).
(c) At wiring harness connector for
solenoid, place a jumper wire from
contact 1 (wire 901-WH) to contact 2
(wire J807-BK).
